A sound system that was tuned well on day one rarely stays that way without care. Loudspeakers get moved, amplifier fans clog, connectors corrode in Florida humidity, and settings get changed by well-meaning hands. Divine Audio Solutions services permanent sound systems in houses of worship, nightclubs, restaurants, bars and live music rooms across Central Florida, including systems installed by other companies.
System audits
An audit is the starting point when a system "has never sounded right" or you are planning upgrades. We document what is installed, inspect its condition, measure the system in the room, and check coverage, level, frequency response and intelligibility. You receive a written report that separates what is working, what needs repair and what is worth upgrading, prioritized by impact and cost.
Tune-ups and optimization
Many systems underperform because of setup, not equipment. A tune-up reviews loudspeaker aim, signal flow and gain structure, then re-equalizes and re-aligns the system using a measurement microphone and analysis software. Often the most cost-effective upgrade is getting the full value from the equipment you already own.
Repair and troubleshooting
When something stops working (a dead loudspeaker, a hum, a buzz, dropouts in wireless microphones, an amplifier going into protection), we diagnose the cause, repair or replace the faulty component, and verify the system afterward. Common causes include failed drivers, ground loops, damaged cables and connectors, overheating amplifiers and wireless interference.
Planned maintenance plans
A maintenance plan schedules regular visits so problems are found before they interrupt a service or a busy night. A typical visit includes:
- Amplifiers: check operation and protection status, clean filters and fans, verify ventilation and rack temperatures.
- Loudspeakers: listen to and test each loudspeaker, check for damaged drivers, rattles and loose mounting.
- Rigging: visual inspection of mounting hardware and safety attachments.
- Cabling and connectors: inspect for wear and corrosion, re-seat and repair as needed.
- Wireless systems: check batteries, antennas and frequency coordination.
- DSP and console: verify settings, apply firmware updates where appropriate, and back up presets and scenes.
- Performance check: a quick measurement to confirm the system still matches its tuned baseline.
DSP preset backup
Processor settings and console scenes represent hours of tuning work. We keep dated backups so that after a factory reset, a failed unit or an unauthorized change, the system can be restored to its tuned state quickly.
Re-tuning after room changes
New carpet, seating, acoustic panels, a stage extension or a renovation all change how a room sounds. After a change, we re-measure and re-tune so the system matches the new room.
Training refreshers
Teams change, especially volunteer teams. We offer refresher training on the system as it is set up today.
Our process
- Consult about the problem or your goals.
- Site walk and audit with measurements.
- Plan you approve: a written scope for repairs, tune-up or maintenance.
- Service and tune, with verification afterward.
- Training for your operators where useful.
- Ongoing service through a maintenance plan or as needed.
Frequently asked questions
Do you service systems installed by other companies?
Yes. We service most professional audio systems regardless of who installed them.
Our system sounds worse than it used to. Is it broken?
Possibly, but often it has drifted: settings changed, a loudspeaker failed or the room changed. An audit will tell you.
How often should a system be maintained?
It depends on use and environment.
Do you back up our settings?
Yes. Preset backups are part of every tune-up and maintenance visit.
Can you help with wireless microphone interference?
Yes. We check frequencies, coordinate channels and improve antenna placement.
Request a site visit
Tell us what is happening with your system. Request a site visit · [email protected]